Motion Sensor

Hint: Always add your smart devices in the same room your HUB is installed. After the device is connected you can move it to its desired location and test range.

Step 1

Hit the button in the Ozom App to set the Ozom Box into search mode.

Step 1

Step 2

Remove the battery cover and then the battery tab labeled “Remove to Pair”. The sensor's blue LED will flash while searching for the Hub.

Step 2

Wait some time (up to a few minutes) before the App connects to the sensor and you see the device tile in the dashboard.

The device will be ready when you see its new tile in the dashboard. Assign the new device a name and enjoy!


Troubleshooting

If adding is not successful, wait until the blue button turned blue and press it again to set the HUB into search mode.

Remove the battery cover, the battery and wait ten seconds.

Step 23

Press and hold the reset button while reinserting the battery. Hold for an additional two seconds and release. Note: The reset button is a small white button located on the side of the motion sensor.

Step 4

Wait some time (up to a few minutes) before the App connects to the sensor and you see the device tile in the dashboard.