Indoor 942L - DLink

Hint: Always add your smart devices in the same room your HUB is installed. After the device is connected you can move it to its desired location and test range.

Specifications for the supported device model
Brand: D-Link
Name: Network Surveillance Camera
Model: DSC-942L
Hardware version: B1
Firmware version: 2.0

Step 1

Plug the camera into a power outlet. Important: Wait two minutes until the light at the back of the camera turns solid red.

Step 1

Step 2

In the App go to the dashboard page and click on the "Add a new device" button (see next image).

And then hit the button in the Ozom App to set the Ozom Box into search mode.

Step 2

Step 3

Press the white square-shaped button at the backside of the camera until the WPS LED turns blue, then release the button. The LED will start blinking in blue, indicating that the adding process has started.

Step 3

It may take some time (up to a few minutes) before the OZOM App connects to the Camera and displays a progress bar. The device will be ready when you see its new tile in the dashboard.

Assign the new device a name of your selection and enjoy!


Troubleshooting

If adding is not successful, the camera might need to be reset. Use an unfolded paper clip to press and hold the RESET button at the backside of the camera for 15 seconds while your camera is plugged in. Wait 2 minutes for the camera to restart.

Try adding the camera again, starting from Step 2.